Week 3

TinkerCAD explorations:

The Cube is a half inch wide cube with a quarter inch diameter ball inside of the cube. the holes on each face of the cube have a quarter inch sized hole making the cube hallow. while in real life it is printed at double the size, the cube being a square inch and the sphere being half an inch. It was created by first making a half inch square, then you are going to make a quarter inch hole on all of the faces making the cube hallow. lastly you make a quarter inch sphere and put it inside the cube. 

The design I Found on tinkerCAD was another coat hanger. This design is a lot more simple than our design it is simply a basic coat hanger. it has a reticular prism with rounded edges. The hook its self is just a pole with half a sphere on top of the pole.

Gadget Design:

In the other groups designs all were advanced they all used a wide virility of tools used, most used holes and grouping to make parts that were not available. the headphone holder used grouping, while the toothbrush holder used both holes and grouping. The last was the case for an arduino board. this was the most advanced using many groups and holes.